Skeleton Entryway Pots

skull-entry-way-pots-smm

Skeleton Entryway Pots

skull-entry-way-pots-12-2

Materials:

  1. Dollar store skulls (lots of them- I purchased a case from the dollar tree)
  2. 2 each Dowels (I used one that was about a 1/2″ thick)
  3. 2 each Foam Balls (large)
  4. 2 each Large outdoor pots
  5. Spanish moss
  6. Glue
  7. Scissors
  8. Misc. Skeleton parts
  9. Misc crows

Directions:

  1. Glue a large foam ball to the bottom of your outdoor pots
  2. Add filler foam around the foam ball to give extra stability
  3. Take a large dowel and poke it down the center of the foam ball
  4. Cut a hole in the top and bottom of your skulls (do this randomly so they sit different on the dowel)
  5. Thread your skulls down the dowel until it is the desired height
  6. Glue some spanish moss randomly between the skulls and fill in the pot (let some hang over and pile up in places)
  7. Place extra skeleton parts in the top of your pot (poking some into your spanish moss)
  8. Glue some crows on and enjoy

skull-entry-way-pots-8

skull-entry-way-pots-1

skull-entry-way-pots-2

skull-entry-way-pots-3

skull-entry-way-pots-4

skull-entry-way-pots-5

skull-entry-way-pots-6

skull-entry-way-pots-7-1

 

skull-entry-way-pots-9

skull-entry-way-pots-12-1

skull-entry-way-pots-11

skull-entry-way-pots-10

This post contains affiliate links

Terms of Use, Privacy Policy, Disclosure, Disclaimer